Ok, so i was driving like normal when I looked to see what last speed run pass was, i liked it and checked where volts and temp were, but i had a 0.0V reading. I could still drive, everything worked except voltage. Looked under lid and found this-
It's blurry, but you can see the wire is broken. I don't know if i can re-solder that? Or do i need a new wire? Any help would be appreciated
Well, it looks like it either snapped off, or came out of the connection. You "should" as far as I know be able to re solder that back together.
The Wolf is not concerned for the sheep's opinion
The pic is bad, but the wire did break off. The problem is i may or may not have bent the little pin trying to get it out 😅. Can I try and still get it out? Or just garbage it?