qr-1 acting funny.. sometimes
i crashed my qr-1 into a door frame. not too hard. nothing that hasnt happened a lot before anyway.
and when i tried to take off for the first few times only 2/4 or 3/4 motors would run, obviously wouldnt fly.
but i can pick it up, and can move the throttle up/down back/fourth a little and get them to straighten out. any ideas on whats goin on?
also, i discovered when i do the reset where you put the throttle to the bottom right and move the right stick back and fourth it seems to fix it
Ive found with mine after a crash if u let it sit for a few seconds it starts to work as it should
got one motor that wont spin freely. will spin with remote, just not when i turn it myself.
tried the 'armature adjustment' with no results. any other ideas before i just order a new motor?
Not sure realy ive had a few blades get pushed on so far that the motor wouldnt spin but it wouldnt spin at all
I had the same problem with one motor not moving freely. Called Traxxas and they sent out a new one for free. Took about a week to be delivered. But I order them online to stock up on them. Dollar hobbyz has all four for $20
Sent from my SCH-I535
ya i found one online for around 7 bucks with shipping and all. not too bad.
we just became a dealer at work, so ill be sure to stock up on at least one of everything cause im sure ill need it lol