what a difference with the castle sct system was worth the 104 bucks, more power speed and with the sct x trenchers it will back flip.
half throttle down the street then nail the throttle pulls the wheels off the ground
and im still running the stock spur and 16t pinion
indeed its a huge difference its a whole other beast now im only runnin a 12t pinion but that fast enough for now im gettin my new wheels, tires , body and some aluminum goodies this weekend so will get some pics up as soon as its completed
How is the performance/driveability on low speeds compared to stock? Got my Telly yesterday and will probably go BL when the Titan dies
But I can't find any waterproof sensored BL ESC's
Don't think they make a sensored brush less waterproof I searched for my wraith couldn't find anything
Slugs are just naturally aspirated snails
Um, the VXL-3s ESC is more than capable of running a sensored motor, with the sensor wire plugged into that port in the ESC. A friend of mine is running a Tekin 550 sized Sensored Motor with a 5mm pinion shaft (3300kv, IIRC) with his VXL in his Slash without a problem, and yes it uses a sensor wire.
revolvers and flatirons
What width revolvers
p/n are 82232 for the black or 82233 for the crome they are rpm rock crawler wide wheelbase wheels
Last edited by dhar186; 01-20-2014 at 08:22 AM.
cool i was looking at those the other day but didnt no if id get wide or narrow
how do the flat irons handle at speeds
They are ridiculously soft so they flat spot in no time. When you first drive after sitting for more than 5 minutes your truck will bounce up and down until they round out again. They roll way too much in turns and they are extremely difficult to balance.
All of this makes them a crappy tire for flat surfaces, but they kick *** on rocks as crawler tires. I love my Flatirons on rocks!
gmade g airs are the way to go in my opinion
ok so my wraith build flat irons will b good...but as for a brushless telly no good
i guess ill stay with my sct trenchers x and proline beadlock sct wheels
finished now need to get a light bar
Last edited by dhar186; 01-25-2014 at 06:35 PM.
Shouldn't have to due to offset of the wheels
Thank you very much