Been awhile building this one but had to share the pictures. ball ends front upper arms and axles are all that's plastic for the most part anyway
someday I will finish it all up.
Wow! Don't crash that!
Thats a nice car is it a show piece or do you plan to drive it and did u use the graphite upper deck as a stencil to make one out of aluminum ?
Yea it would hurt.. lol
So far its been on the shelf but when I find time to finish the engine and such I will run it someday. I don't plan on tearing it up running it but I will run it. They clean up. lol
I actually used stock plastic top plate and rear brace for pattern to cut the aluminum from for the most part. then later done some trimming to get close to the graphite. its been awhile back.
I plan to do a few more later and have them powder coated. not sure how that's going to work but going to try it.
Last edited by slopoke101; 06-04-2013 at 10:50 AM.
approx. how much more does it weigh over a stock 4tec?
not much really, I will have to check and let you know. I as you see don't get on here often.