I have a Summit with and DeWalt 820 14.4v motor.
What motor should I use under Model Setup on my TQI App ?
Just use the 775 it's pretty close
Sent using lipo power
Mountains cant stop me
they have tried
Ok, thanks a lot bud!
Is so slow this DeWalt, with 20T pinion and 62 spur can't go faster than 40km/h - 25mph!! I was expecting at least 50km/h 30 mph
Speed runs, anyone?
I'm joking, kinda...
OMG I found a 32t 32p
On second thought, I'll bet none of these would even fit...
Last edited by Deviate; 10-30-2013 at 10:17 PM.
Brushless 19/62 SPC 8.2 It's not a Tekin or a MM
You could use those gears just for quick runs, I believe Northern Adventurer did high geared speed runs and pull around 40-45mph on Road Rages
Slugs are just naturally aspirated snails
Or a smaller spur gear, but it may overheating the ESC.
Not sure what's the maximum supported by the EVX-2 in terms of pinion and spur gear.
I guess the motor is pretty strong to handle them.
Did anybody any tests with bigger pinon than 20T and smaller spur than 62T on the DeWalt 820 14.4v ?