Not sure if this write-up has been done before, but I finally got my Stampede 4x4 shock guards on my 2wd slash. To answer my previous question on the forum, they will fit with no cutting!!!!
Here are a few pics of the install.
I bought some longer stainless screws and a couple plastic bushings. I cut the bushing to fit at an angle. I also had to drill a small hole in the arm. The screw went into an existing hole in the shock guard and then into the hole I drilled in the arm.
Here is the final pic. I used the screw supplied with the kit for the one attached to my shock. I used the old shock screw on the outside of the arm for strength out there. I then added the new stainless screw and the bushing on the inside for strength on the inside.