Results 1 to 3 of 3
  1. #1
    RC poster
    Join Date
    Feb 2014
    Posts
    8

    throttle/ brake servo gear set problem... help please!!

    So the other day I got rammed into by a savage and it broke the main gear of my throttle servo. I went and bought the gear set and replaced it. Now when the truck is on, and in idle, it is running at half throttle without pressing the trigger... I have full braking capabilities and when I release the brake, again I'm running and driving at half throttle without pressing the trigger... Anyone have any suggestions? Or where I should start trouble shooting?

  2. #2
    Marshal Double G's Avatar
    Join Date
    May 2008
    Location
    Putting the wet stuff on the hot stuff
    Posts
    10,364
    Did you install the servo horn with the power off or on? Best to remove it, turn the electronics on and center the servo then install the horn.
    The Super Derecho

  3. #3
    RC poster
    Join Date
    Feb 2014
    Posts
    8
    i installed the gears with electronics off, then turned electronics on and let it center itself then put the horn back on. i did it a couple of times to make sure and it still goes about half throttle when i release the brake.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •