First off, I notice the HEX's ( think that's what there called ) but the front and rear are different sizes and colors ? Are these stock ?
- REAR -
Second thing was when changing the bearings on the front carriers I notice only the outer bearing can be replaced and the inner is built on the axle shaft ??
Yes the hexes are different width front and rear
No the bearing is not "built in" to the shaft. You should be able to pull it off
yes the black i had on my slash stock when i got it and the grey was on my sons rustler i bought used 3 months ago. pins fine bearings nice n blue. when the blue starts discolouring i usually consider them backups or garbage. hexs are fine until they round then get the aluminum ones there pretty cheap and wont wear anytime soon after purchase.
Some people will take the front hex and put it on the rear to get the max allowed wheel track.
With out going over,I have been unable to achieve this feat,I'm always to wide,or don't have enough axle threads exposed to grab a hold of.
But the extra width is normal.
And as stated above also,both bearings will come off.
Sometimes they will put up a fight. Before you put you new ones on be sure to clean the stub axle up,and check for bend-age so the new ones will slip right on.
Last edited by billy-bones; 05-09-2013 at 08:05 AM.
Built Ford Tuff With Chevy Stuff.
If you can't get the bearing loose try this: Stand the axle up with the bearing on the top, then put a deep socket over it and try to hammer it off. Don't go crazy with the hammer lol, just tap it easy. I'm surprised it came out of the bearing carrier and got stuck on the axle.
Definitely not one piece, here is the stub axle:
There are many aftermarket bearings also, just make sure they are 5x11 for there.
Thanks guys I got the bearing off with JOE's advice and I replaced it with Anza bearings sooooo smooth now