I just installed my new evx-2. I get a solid red light on the esc. the motor goes foward and backward, and the servo works. is it just stuck with ldv off? I also calibrated it.
did I buy 1 that isnt lipo approved?
Last edited by jpierce81; 03-24-2013 at 09:47 PM.
It will say low voltage detection right next to the on off button if it has it.
l_l O l_____l O l
if im not mistaken, solid red is NO lvd for nimh, solid green means lvd is ON for lipo. I may be wrong.
You are right, solid red is lvd off for Nimhs, and solid green is lvd on for lipos. I did have an issue with the lvd before, make sure and plug in your lipos and hold the esc button down for at least 10 seconds the esc will chime and the green light will come on, good to go with lipos. dont try to engage the lvd with nimhs or it opens a different can of worms.
thats what was wrong with it. thanks also had to change profiles after that