Hi everyone, just wondering if anyone has these rockers http://www.hobbyetc.com/item.cgi?part_id=62557\
I just dont want to pull the trigger if anyone has had issues with these rockers? I mostly do a lil light ofroading and high speed bashing in parking lots. I see the above mentioned rockers have two mounting holes, for progressive spring tension. Any thoughts?
Thanks everyone in advance.
Those look good!
Last edited by 50togo; 02-03-2013 at 06:41 PM.
50 what do u run?
I was also looking at ordering this engine mount to help assist with some heat transfer http://www.hot-racing.com/index.cgi?...=VXS1801;c=455
I'm running 3 cell and 23 tooth pinion, want to help the motor as much as I can with keeping the temps down and some heat transfer awat from the motor.
I run gh rockers on my merv. Work pretty good!
I have that mount on my other merv. No complaints!
Last edited by 50togo; 02-03-2013 at 06:54 PM.
They also make them in carbon fiber. Debating aluminum or carbon fiber at this point? Any thoughts hehe?
I would go aluminum
This is on my erbe
Last edited by 50togo; 02-03-2013 at 07:29 PM.
Would carbon fiber be too brittle on jumps and abuse? I love the carbon fiber look, just worried about longevity.
Ok so Aluminum it is!! Thanks 50!. Hows the aluminum with flexing and on jumps 50?
Hey 50 who makes the chassis brace ? you? (right above the shock condoms )
I like that
Never mind, that's a "monster" revo i now see
Last edited by photon_trap; 02-03-2013 at 08:16 PM.
There are lots of ways to do that. Most are wrong.
I like turtles.
What do the chassis braces do?
So the product descriptions state they are rear rockers, and i dont see front rockers? Can I order 4 rear rockers, and use them all around on 4 corners?
I like turtles.