Ok I was wondering can I run the stock drive shafts with the mmp 2400? Even if I adjust the punch control? What should I set the punch control at with running the stock drive shafts? I will be getting tekno rc driveshafts. Later on.
Sent from my Samsung NOTE 2.
Get teknos. Stockers will twist and be junk.
With the mmp 2400 my stockers lasted 1week on 2s and 2 minutes on 3s. Then igot some mips
The 2400 will break the stock axles real quick. Go ahead And order the cvd's so you have them on hand when the stock axles break
If you are gentle with them, they can last awhile. I have Mip X-Duty's so I have no worries about that. Until you upgrade take off slowly and you should be ok.
Member of the 10,000 + posts club! Here to help!
I run only tekno's rear on 3s to keep it cheap,and no problems.
If you run 4s you should get a allround set.broke some stockers already.
Mip X's cvd's baby!!!!
I am still running the stock cvd's but I am running stock tires that are pretty much bald. Once I get new tires I bet they will not last long.