We have a sand blast booth at work, and im tempted to take these Rulux rims in and get the remainder of the black off.
Will/could that potentially hurt the rubber? Plenty of life left in the mashers, but the paint is just terrible.
(bought em with the paint on them)
Its a very fine grain media blast booth, almost a powder.
What do you think? I was just gonna respray them black but it wouldn't last, i would rather just blast them back to yellow. Provided it shouldn't harm the tires.
(RAH)² (AH)³ + [ROMA (1+MA)] + (GA)² + (OOH)(LA)²
I don't think it would. Especially with a fine media like you're talking about.
Sent using 8.4 volts of NiMH power!
To the men and women of the US military, thank you
I don't think it would either. You could put like painting tape on the tread and then something stronger over that like duck tape. The painting tapes just to not get goop on the tire.
just spray oven cleaner on the rims takes paint off good you might have to scrub with a old toothbrush but works fine
ERBE, ERBE, Summit, Slash 4X4, Bandit,