So. My buddies came up with a ridiculous Idea but I think I will have the best chance.
His idea is a demolition derby for rc cars.
Rules are have to move on own power and if flipped over by another rc then game over. If you flip over on your own (turning) then your still in. 5-10 dollar buy in. No reinforcements only can buy bolt on parts.
I've been thinking about it and I know that I'm the only one that has a summit out of all of us and they mainly have 2x4 and 4x4 slashes and smaller.
It's been eating at me and i keep thinking that I may have a killer chance cuz of the electric lockers and size.
I was thinking of dropping it as low as possible stock wheels and tires motors and batteries. I also was thinking rpm bumper mounts and Tbr bumpers and a ARM skidds for protection. And a lot of duct tape on the corners and sides of the inside of the body. I also thought about a roll cage but I really dont want to spend a lot of money.
What do all of you think I can do to make it so that I can win.
l_l O l_____l O l
Im sorry, i'm out of this one. My summit cost too much to have other guys purposely trying to bust it up
MAN, Use Common Sense.
Outside? THERE IS NO BOX !
^ I'm in the same boat. I'd like to see it done with somthing cheaper, like brushed pedes. Fun idea though. Good luck if you try it!Im sorry, i'm out of this one. My summit cost too much to have other guys purposely trying to bust it up
The Wolf is not concerned for the sheep's opinion
l_l O l_____l O l
Save the summit from the Derby. Is go with slash on slash.
Sent from my ADR6350 using Tapatalk 2
IMO, its not a fair deal at all. Thats like putting a monster truck in a normal crash up derby. The summit will literally drive OVER a slash and, in reality, wont do much damage A slash on slash impact would be worse IMO than a slash on summit impact. The tires will actually protect the car you hit.
If I were your buddies, I wouldnt want to let you in on the game unless you run a 1/10. It only makes sense if its a reasonably level playing field. Either way, film it. I want to see.
I have to agree, do you really want to take the risk with your summit. Well if you are dead set on doing it consider a few things, no matter how low you drop your summit they are still going to be smaller, with lower center of gravity. One good run at you side ways they will get under you enough to flip you easy. You running at them is no good either you will go over top & quite possibly flip in the process. think of it as David vs Galyth you bigger, stronger, & badder but not unbeatable. Still if your still set to do it drop your summit as low as you can consider weighted bead locks for rims & find a way to drop the bumpers even lower so you can get it under them, may take some tricked out modding but if you can do that you stand a chance..... Oh & video tape it we all want to see that.
Don't take it out unless your going to use it.
13 motors in your real full size truck? Wth are you doing
Xerun 150A 2200kv ERBE
Dewalt 14.4v Summit
I have my $200 Summit lowered, would that be low enough for your Derby?
ERBE, ERBE, Summit, Slash 4X4, Bandit,
Haha. I'm proud to say I'm still all samurai.
l_l O l_____l O l
^ I like the realism the sheet metal added...still too expensive for me though
Sent from my iPhone using autocorrect
I think you should deepen the pot. You're gonna win.
PM me for help converting your Summit to brushless
I don't think you should put your summit in. If you are, just keep it stock.
Last edited by junkyarddogs71; 01-20-2013 at 06:35 PM.