After burning through two Velineon motors I had to resort to borrowing a good friends castle motor and esc combo so we could continue our routine weekend mayhem. I just received my two new Velineon motors from Traxxas and now need to install one back into my Slash. When i first purchased it there was nothing i needed to do but flick a switch and it was ready to roll. Now that I've bound the contoller to this castle esc I will now have to rebind it to my original Traxxas esc correct? Whats the process for binding the stock system is my question?
Same thing with all rx systems
From traxxas anyway
I think this is what you are looking for. http://traxxas.com/support/Programmi...-Speed-Control . The other link is how to program the radio and receiver. This is for the radio and esc.
Member of the 10,000 posts club
I know this is a little off the topic but didn't want to start a tread. How do I set my throttle end points? I want to change it to 70/30% I followed the instructions that came with the controller but when I finished and turned my truck on my esc just blinked green (I have LVC on).