Velinean rebuild question
Just put new bearings and bushing in my velinean brushless motor....and it seems to have about 1/16" play when moving shaft from end to end. No play side to side. Was wondering if this was normal. I have the current style motor with current style rotor....so I used the new brass bushing (D).
Again, not a lot of play...just about 1/16...but it didn't seem to have that much with the old bushing.
i would take the old bushings and compare them to the ones you put in. if theyre different you used the wrong set. Then compare them to the other ones and see if any match up better