Hooking up telemetry to 2218x
Ok kinda new to all this stuff I ordered temp, volt sensors and power tap. I have the tqi docking base from my slash. So I plug the volt/temp sensor into my 2218x and the power tap. I get nothing on the dash board. I paired the controller to the truck and it the steering and throttle works. I tried to plug it into ch 3 4 or 5 and nothing. What step did I miss? I also got the mount for temp sensor but not sure how to mount it any got a pick of there's mounted up?
2218x is not telemetry ready I believe
Does it say TQi on ur reciever?
There should be a spot(slot) for, volt/temp and rpm
Last edited by Daddykins; 01-12-2013 at 03:46 PM.
Dont see tqi on it well darn it. Well I got all the stuff for my slash I can get it working on that truck till I get another receiver.
You can always switch out the receiver on the slash n mini
Or use it for ur slash if u got all the necessary parts