Results 1 to 3 of 3
  1. #1
    RC poster
    Join Date
    Mar 2014
    Posts
    15

    Tqi 3-additional 2 position switch

    Ok guys, on my tqi 3 that i robbed from my tmaxx to use on my emaxx, I modded the 3rd channel to use for my winch. I am adding a back winch, and was wondering if I could install a separate 2(or 3)-pos switch to change between the front and back winches. I know that I could build a "Y" with a switch coming out of my receiver, but I would like to be able to switch between the two.

    Thanks in advance!

  2. #2
    RC Champion
    Join Date
    Dec 2014
    Posts
    1,062
    I don't think you can achieve what you are after with 3ch. Output signal of a typical receiver is PPM and they have dedicated time slots for each channel. Since it's a winch that you will need to hook and unhook, perhaps a single pole double throw momentary wired remote will do.

  3. #3
    RC poster
    Join Date
    Mar 2014
    Posts
    15
    That's what I figured. Just thought I'd try it though. Thanks for the reply!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •