I recently purchased a used revo that needed some work. It had no axels in the front. It has a 3.3 engine. I ordered a set of axels for a Nitro revo 3.3. When I recieved them they were larger in diameter, about 3/8" longer and the shaft that goes through the wheel bearings is about 3/16" to short. Are there early and late model revo's? Does anyone have any ideas?
All the Revo axles should be the same. Only Revo platform that got fifferent axles I believe was the Traxxas Summit.
One shot.....One kill, no exceptions
Post a pick it sounds like it may have T-Maxx axles on it or it is not a Revo maybe an older T-Maxx because those had smaller axles on them.
Drive it, Break it, Upgrade it
Make sure that the bearings are fully seated in the axle carriers and that the axle is completely seated too.
The Super Derecho