From what I understand, loose rear diff housing in the bulkhead is normal and I only noticed after rebuilding the rear end. I assume until now my case was tight because of the trapped dirt and rocks
Can you guys confirm there's nothing to worry about and that in time it'll sit still because of trapped debris... or do I need to add take it all apart again and add some foam etc...
Loose rear diff housing in the bulkhead is normal... No need to worry...
He Who Dies With the Most Toys Wins.
Yes, it is normal for it to move around in there some. I don't necessarily like it, but it wont really hurt anything.
4wd Sportmaxx 3.3
E-Revo - Mamba Monster - Neu 4s
I stuck a bit of foam in there to reduce it a bit,last time it was apart.a member here used hot glue interested to know how that's doing.
Sent using lipo power
Mountains cant stop me
they have tried
Ok I feel better thanks everyone.
I also put a couple of dobs of hot glue in the bulkheads before I reassembled. Quickly of course so it was still soft. I didn't fill the bulkhead after assembly as in the thread referred to above.
Summit 11/68T 4S 2000kV
E-Revo 14/56T 6S 2200kV
I did that. Works great, and it comes out very easy when you need it to. I used my Summit for 8 runs since I put the hot glue in, and it's holding up well! I'll see if a can get a picture of it...member here used hot glue interested to know how that's doing.
Last edited by Wolfslash16; 01-05-2013 at 11:16 AM.