Castle mamba monster 2 esc
anyone running one of these on the spartan?
i've just blew up my castle hydra 240 after 2 mins of run so looking for something waterproof now
i've taken the fan off the mamba and the heatsink is roughly 32mm x 32mm wide
i've found a computer heatsink on ebay 30x30mm
gonna thermal paste is on and see how it goes
good idea or not ?
How did you blow a hydra 240? I hope it wasn't the stock setup, because there must be something wrong there...
long story short, was a bit too excited and didnt waterproof it / spray any waterproofing stuff in it
2 mins in i torque rolled the boat at high speed and it sank
it was running stupidly fast tho, haha
also not really worth me sending back to castle as its $190 replacement but will cost about $40-$50 to get a tracked shipping service from aus to the usa.
where as if i wanted a new hydra its only about $270-$280ish new....