So my issue is: installed hard steel CVD and am now braking the rear right (looking from the rear) CVD within 5 mins of installation. are there any ideas as to why??
The location of breakage is on the threaded axle itself.
Vehicle details are below:
Slash 4x4 Ultimate spec
3.8" Stampede Wheels
Hobbywing 120A esc http://www.hobbywing.com/product_show.asp?id=278
Hobbywing 2000kv motor http://www.hobbywing.com/product_show.asp?id=241
Turn1gy 14.8v LIPO (2x 7.4v)
Last edited by bongo; 11-08-2012 at 06:14 PM.
Land of the free?
Where they the MIP ones?
willing to bet it is caused by the larger wheel's.
*Proud Husband of United state's Air Force wife.*
They shouldn't be breaking because of that wheel size. My friends run bigger sizes with thier tekno's and mip's. I'd be calling Traxxas support. Hope you find a good solution.
Thrash It, Bash it, Break it, No Regrets!!!