Cannot get TQi Transmitter out of flashing LED green mode - PLEASE HELP !!!
When I turn on the TX it just flashes green fast.
The manual says it is in "throttle Trim Seek mode" but I cannot get it out of this mode. I have done the following already.
1) turn the multi function knob in either direction - did not resolve
2) Set the TX to factory default (press set and menu before turning on then hit set after LED flash red) - did not resolve
3) Try to enter the programming mode (to actually program the multi function to throtle trim) but pressing the menu for 3 sec - does not seem to enter programming mode and led just continues to flash green fast.
The TX binds to the RX and I can get the motor to work but when I turn the wheel on TX, the car's steering moves after a short delay and not smoothly
If I leave the TX on for a long time (20 sec) the LED blinks green but intermittently and once in a while (like every 5 seconds or so and only a couple of faint blinks)
I am confused ???
Last edited by eflyer; 09-29-2012 at 09:35 PM.
So I found out this was due to low battery condition???!!!
Why wouldn't the TX LED blink red is beyond me. Looks like their low voltage circuitry is not working correctly....
I have the same problem. Was it the batteries in the TX or the truck??? I thought that it was me
Originally Posted by eflyer
Thanks for sharing