Results 1 to 16 of 16

Thread: My custom NPede

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    RC Champion
    Join Date
    Mar 2012
    Location
    Dawson creek bc
    Posts
    1,115

    My custom NPede

    I started with a stock Npede and turned it into this monster in the pics. I'm not quite done yet, I'm still waiting for some tire foams so I can glue the tires


    Here's the upgrades:
    A Trx 2.5 engine w/ pullstart
    Jato side pipe
    Jato wheelie bar
    STRC aluminum shocktower
    STRC aluminum front bulkhead
    STRC aluminum front skid
    Stampede 4x4 proline protrac kit minus the shocktowers
    Integy 17mm hexes with 12mm offset
    OFNa 1700 MAH humpback with a fancy Traxxas switch
    3.2 Rpm revolvers with chevron tires
    Dubro fuel filter
    Proline ford raptor body

    With the protrac kit and 12mm offset hexes it sits wider than my classic tmaxx

    I had to convert the front end to electric to run the 17mm hexes all around
    The rear stock shock tower wouldent line up properly with the new body
    so with a bit of drilling and sanding i now am running a tmaxx rear shock tower








    I had a new tqi that I tried to install but the plastic that holds the rx is not the same shape
    Does anyone know any good ways to waterproof this thing, the servos and rx are pretty exposed
    Last edited by Kyleb; 10-12-2012 at 02:02 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •