Hi all,

Couple of questions. Firstly I've replaced most of the bearings in the 4x4 except on the exploded view I can't see to figure out how to remove the 2x 5117 6x12x4 bearings? On the rear diff the cog just falls out exposing the bearing that you just push out, but the front seems to have the drive shaft attachment screwed in?

Also, I'm looking to use a larger wheel/tire to increase ride height but I'm not sure what sizing to look at. I've increased ride height with longer stiffer springs and I'm now using the RPM body mounts on the higher setting so there is a lot of space to play with. Would I also need the 17mm hex adaptors?