Long story short. old carb cracked. Bought a new one. But the horn for the throttle servo is upside down from the old one and it binds my servo a little. Can this be adjusted on the carb? For reference the old carb when looking at it from the lsn, the horn is at about 130. new one is at 730. any help?
The servo linkage on the carb has a small hex set screw on it. it is 180 degrees from the linkage arm on the throttle, you can loosen that screw and align it.
All Lives Matter
United We Stand, Divided We Fall
Thanks for the quick reply. I've never noticed that set screw and i've had it apart probably 20 times. But your absolutely right. That fixed it. Thanks again.