I'm just sitting thinking, "wait... will the shaft on my new motor fit?"
Who here has an aftermarket motor and had any issues? I think the stock shaft is something like 13mm and the one I'm getting is the more "standard" 17mm, that's a big difference IMO, but haven't opened it up to see clearence - not at home right now.
Can Diameter: 46.35mm (1.8")
Can Length: 67mm (2.6")
Shaft Diameter: 5mm (0.20")
Shaft Length: 13.5mm (0.53")
Turns: 10 turns
(per Tower Hobbies)
I am sure you have a Dremel
Or can at least drill a hole in the plate.
Whatever it is I just typed... could be wrong.
If that's all that's needed, than year certainly can. I can't remember where the shaft heads from the motor, so I was afraid it maybe would try to protrude in to the tranny or something.
Thx mang! =)