I have a 1/16 e-revo vxl brushless and bought a 4 channel TQi Transmitter with 6518 Receiver. When i was trying to bind it the transmitter and the receiver started blinking red really fast. The battery on both were fully charge. I have no idea what is going on. Could someone please help me out? Thanks
Last edited by BunsoAko; 07-14-2012 at 10:03 PM.
Ok I just figured it out. hold set button on transmitter... then turn the transmitter on... release set button... hold button on the reciever on the merv... turn merv power on... then release.... lights on both things should be green and good to go
ERBE, MERV BB
i know bumping your thread mote often than once per day in other forums here will result in your thread being deleted and action sought against you
I have tried that but it didn't work. I ran to another problem. When I took the servo connection from the receiver I was able to bind the transmitter and receiver but when i put it back the red light in the receiver started blinking red rapidly. Do you know what that is happening?
I am having the same problem hopefully someone can chime in....
Whatever it is I just typed... could be wrong.
I figured it out... I do not know why but I had to do the opposite... turn on the TQi link first then the TQi radio control; , but, now it works flawlessly...
Always transmitter on first, off last
Merv: Neu, MMP
can drive around the apartment with it hooked up and no issues. only does it when so far away from me.
im having similer issues to this
I have the TQI telemetry on my jato got it to bind, I have 3 other models that I want to put on the transmitter but can't get them to bind. I have the 6518 reciever and followed all steps for binding, no luck. can someone help me with this problem. I have also updated firmware.