Well, I've loved my slayer and it's been great so far. Except for when the throttle sticks at about 1/4-2/4 throttle. When I start it, it idles just fine with out moving, but after I warm it up and do a WOT pass, it will stick and stay there untill the truck comes to a complete stop. It will also creep forward at 3-4 mph at idle after it warms up too. While it's moving at full speed and I let go of the throttle, it will rev down to idle, then go back up to half throttle and stay there. I've tried adjusting the idle speed screw so I have to hold it at half throttle just to start it and it will STILL continue to stick. I've checked the throttle linkage and the carb, and I even checked the engine while I had it apart. If I hold my slayer off the ground and let it get up to about 3/4 throttle and I let go off the throttle (I let it go back to netural) the servo will go back to idle, but the engine continues to rev up to half throttle even though the carb isn't moving AT ALL when this happens. I have no idea why the throttle is sticking, and I've tried everything. Why is it doing it? PLEASE HELP ME FIGURE OUT WHY THE THROTTLE IS STICKING!!! It is geting a little worse after every run, and it's starting to freak me out! PLEASE, I NEED HELP!!!