I just got my emaxx. I wanted to access my Transmission, but I cant take my center CVD's or Dogbones(Im not sure which ones they are) off. The only way i tried is by opening the whole differentials. They look like this:
There is a 2mm pin screw that holds that CVD drive cup onto the short out put shaft of the transmission.
Rotate the shafts until you see the hex head and use an allen wrentch to take em off.
This parrot is NO MORE!!! This is an ex-parrot!!!
If you have loosened both drive cups, pushed them apart and still can't get them out you'll have to take the 4 screws out holding the chassis to the bulkheads, and the skid plate screws onto the chassis brace+steering belcrank
Last edited by trax de max; 03-02-2012 at 11:15 AM.
Google search trumps Wiki. Refer to user guide.
Can someone please make a video on how to remove them. That would be nice, so I can actually drive my Emaxx for the first time.
I unscrewed both the small screws from each side and it still isnt coming out.
Last edited by ControlledWithRemote; 03-03-2012 at 09:33 AM.
I had to take the screws out of the transmission to give a little bit of play. It gave me just enough room to get the end over the transmission output shaft. Just did it yesterday. Then remount the tranny.
If you've got the screws that hold them in out, they should just slide right off.
If they don't, they may be rusted. Try prying them with a screwdriver, but don't blame me if you break something!