So i was puting my set of sway bars on tonight and i broke the screw that goes into the A arm off in the A arm.....Did i mention they are alum A arms.....Can i get another link for the sway bar without buying that kit? And how do I poss get that piece out of the a arm so I dont have to buy new a arms?
Traxxas has a very strict language policy. A filter operates to convert inappropriate words to *s. When you see these in your post, you MUST edit the inappropriate term.
Last edited by ksb51rl; 02-02-2012 at 01:07 PM.
You can pop the linkage off of the ball joint type screw that goes through it, might make it easier to get out.
You can buy just the front links I think the part# is 6895
ty off to lhs!
How should I attempt to get the broken screw out of the alum A arm??
Is any of the screw exposed or did it break inside of the ARM
The only way I can think of is drilling it out. Which is hard when the screw is that small but if you go just a little smaller and get it centered so should be able to just pull out the rest of the screw with a small pick. If that doesn't work may have to drill and tap it up a size and drill out the sway bar link end
Last edited by shaggyiroc; 02-02-2012 at 08:14 AM.
You may be able to get a reverse drill bit. When you turn it left, it will thread in backing it out. Just make sure its good quality and not harbor freight or walmart special.
Sent from my LG-P509
People Eating Tasty Animals
All I can say is, good luck
Slash Ultimate El Sob special MIP King Headz 3PL
Got it! Used a dremel and smoothed the end of the screw then a took another dremel bit and started a small spot in the center of the screw then i used a drill and the drill bits gradually getting bigger till i was able to get it out!! SUCCESS!! lol
Glad it worked out