how did you guys fit a mamba max pro into your merv??? i really wanna do it but im afraid its gonna take extensive modifications... any help?
on its side
how about the motor??
What exactly are you asking ?
Motor is no different to any 540 sized motor
You need either the Traxxas BB mount or the Tenbol
You will need the Traxxas brushed RX box or modify the existing
Xerun 150 / Tenshock SC401 3500kv
ohhh okok sorry if i confused you guys, but thanks again
i didnt see anywhere you ask about the motor, i run my mmp with the 380
i run it until the batteries run out
they are spc 2200 mah, 2s, i jsut run them in series, 20c, and they also have the large wire upgrade
i get about 45 minutes out of them... usually, i am bored and end the session early
the motor gets quite warm according to my hand, it will sizzle spit off my finger if i touch it, but it hasn't died yet... when it does, i will run an arc
If you take the MMP out of it's case it's really a lot smaller than what they'd like you to believe. Use both the RTV to waterproof it and glue it down! And if you have a dremel just do this with your 380 mount. http://m1143.photobucket.com/albumvi...C9923.jpg.html Don't know why nobody can figure this out? I swear if these trucks didn't come RTR I'd be the only one with one
Sorry that sounded mean. I just ment: don't be afraid to cut, hammer, drill, saw, burn, tape, screw, ziptie or throw it out altogether!