Quick question. Is the internal "star" pattern of the 4x4 center driveshaft constant throughout the entire driveshaft? I know the driveshaft is hollow, but is the internal design consitant through and through? For example, if I am to cut the driveshaft in half, would the "star" pattern still be there?
This is for a concept project involving an extended chassis with two center driveshafts, but one of them would have to be cut a few inches shorter.
Last edited by moneybagsfor-rc; 06-09-2010 at 11:49 PM.
Yes the spline runs all the way through the shaft.