standard camber turnbuckle rod lengths?
I have put some new rods in and don't have a camber gauge. I am using a T square to try and get it right but i'd like to make the standard camber as accurate as possible by going off the lengths of the turnbuckles.
So does anyone by any chance have a new slash or have previously measured the front and rear turnbuckles?
I don't have the Platinum just the standard 4x4
I measured the gap between the rod ends, easier for me this way, 31mm
Ahh ok, so just he silver threaded part then?
Would the 31mm gap be the rear camber rods or the front?
Thanks for the help
Yes, thats right.
31mm gap front, 24mm gap rear
Great! Thanks for the help, I'm sure somewhere down the line this will be useful for others here too..
And it was...over 2 years later.
While we are talking about it...does anybody happen to have the same information for the steering turnbuckles?