Started with the stock slayer... New engine (Bad Crash) engine roll cage, sway bars, pipe and air filter Tires, 2.8 trenchers on desperado wheels and Boom My Murda Slayer! Hope You Guys Dig it... more upgrades to come
Last edited by Jakeb; 07-13-2013 at 11:38 AM.
A few more pics. For some reason I couldn't add them to my other post a few spots up, but here ya go
Ditched the ez start went the glow igniter and pull start route
also upgraded the push rods and toe links
don't know whats next.... created a monster
Now time to put some scratches on it!! Chevy runs deep!!
Last edited by slimwhitman; 10-12-2013 at 09:20 AM.
Last edited by Double G; 07-16-2014 at 07:22 AM.
My new fav! Short chassis 3.3(for now) mods: tekno rx/battery/fuel tank kit, tekno throttle servo mount, losi 8b fuel tank, OFNA 053 side pipe, Slayden steering mod, 100k diff fluid front and locked rear, Teflon GTRs w/3.8 rate front and 3.5 rear, Tigerdrive starter, 2075 servos, modded 12mm aluminum hex drives, Proline pre-mounted Trencher SC, T-maxx 3.3 body(for now). Soon to buy: nerf bars, sway bar kit, modded revo axles, aluminum rocker arm posts pivot balls toe links and push rods. Built from a couple part lots and eBay
Revo P26 T-Maxx P26RD T-Maxx TRX3.3 Slayer TRX3.3
Last edited by dyabinho; 06-22-2014 at 11:17 AM.
This is my mud setup of slayer pro 4x4. 17mm hex hubs and Pro-Line's Masher 3.8" on Desperado black 1/2" offset wheels.
Upgrades-Proline Blocades, Proline Flotek, Center Diff, Rear Diff Locker, THS Pipe, Pull Start, Close Gearing, Tie Rods, Toe Links, Springs, Front and Rear Brakes, Rear Sway Bar (Front keeps on falling off).
Last edited by willyboy567; 12-30-2014 at 10:18 PM.
I decided to spend my new years day painting a new body for my prerunner Slayer:
My wife painted and gave me this body for my Revo 2.5 back in 04 or 05. I could not stand the looks of the stock body so I modified this one to fit.
Just finished her up.....
Last edited by Skrizz1777; 09-11-2016 at 09:16 PM.