Type: Posts; User: MaxxWrecker07
Why don't you just trim out the "windows" from the decal... it'll be black underneath and shiny like glass. :D Looks good though!
It's in store credit. Place an order, and they take $10 off.
I've d-blocked the chassis, save for the green aluminum rockers I bought that I don't like (and can't send back)... I'd like to go with the red parts as it looks nicer. The traxxas rods are awesome....
Sale Pending to Chris95GT.
Bumpity bump bump :D
Bump. Make me an offer.
Up for sale is my new, never used KB Rally servo. This was immediately replaced with another metal gear servo, so it's never been operated. I am asking $20 shipped via PayPal CONUS. Thanks for...
PM sent. :D
You get a great deal when you buy this guy's stuff. :thumbup:
The red light is normal. The wiggle side-to-side happens with my car too. I haven't tried to diagnose the cause yet, but it did it before the gyro. I'm going to investigate the knuckles, as I believe...
That's the one I have. It works well. As for me posting before you... my electrons are faster than yours. :D
Yep. I had the same one... failed in a week. I'd recommend the esky EK2-0704.
Sell your stuff to this person!
3. Servo case: Yes
Finned heat sink: Maybe
I got the rockers... not so green, unfortunately. They are quite pale, in fact. Oh well, at least they aren't plastic anymore.
I actually find myself wishing I could send them back.
The other issue with squeezing the connectors is the lack of electrical contact. When you squeeze them you are only getting two points of contact, rather than the entire circumference. I would be...
CM36 motors are 2 pole. The motors that are 4 pole are labeled Neu XXXX where x is the appropriate number. A good way to tell is to spin the shaft and feel for "notchiness". A 4 pole unit will be...
White wire on esc goes to the yellow wire on the motor. The other two determine the rotational direction. If you pull the trigger and it goes backwards, reverse the two wires. Hope this helps!
Reverse Type: With Reverse (*)
Brake Amount: 70
Drag Brake: 20
Punch Control: 60%
Max Reverse Power: 50
Arming Time: 1.5 seconds (*)
Throttle Dead Band: Average (0.1000 ms) (*)
Yes, but I found it to be more of an aggravation than anything. I have the Castle BEC, which has its output set at 6v, and under full throttle, sometimes the receiver cuts out. I know this is a...
You're welcome. I did run the Mamba Max thru the link, but I can't say what I've set on it. I recently switched out the Mamba for a Sidewinder V2 because of the wire orientation and the price. I'm...
The tie/push rods all have nylon balls. The machines steel ones replace them. Otherwise, I have no idea what they're talking about....
That's the 1/10 scale summit mount. The 1/16 scale mount has another hump on the finned motor mount part.
White wire on the ESC goes to the yellow wire on the motor. The other two don't matter. If you pull the trigger and it goes in reverse, change the red and black wires around. :D
Nice job on the...
Here ya go: