Type: Posts; User: offroader77
thanks ill keep an eye on that ive been runnin 4s an havent had a problem
did u get the mips withe the keyed hexes or are they the older pinned type if pinned u can use the traxxas 17mm hex thats hat i have on mine an love it
nice paint job thats gonna b my next purchase is a body
oh yea i have seen that befor i neer had a vxl setup in it as when i got my truck it was used an ive never had good luck with used vxl got my new batt pack today plus my 17mm wheel adapters so i...
yea he has real good deals i bought two sets of offroad wheels n tires only thing bad i can say bout is mine were not glued good at all so i boiled them off clean them up an reglued n now love them
well cant say about the 3400kv i run a 2000 kv motor stock 54 spur an a 19 pinion only thing i see is i could go up a few more teeth on pinion or drop a few on the spur the way it smaller spur gear...
sold mine local an got 120 out of it
looks like that would b a front wheel that takes a bearing like the some of the jato
http://www.ebay.com/itm/ALUMINUM-12MM-HEX-DRIVE-17MM-EXTEND-ADAPTER-BK-TRAXXAS-1-10-SLASH-STAMPEDE-4x4-/380753461436 try something like these maybe not quite this long but these will push the wheel...
should bolt right up to stock plate as for gearin not realy sure as im runnin a 2000 kv motor stock spur an a 19 tooth pinion that came in a freinds combo he bought for me lots of power an speed oh...
not sure on exact modle but 3905 03 08 series an my hobbywing setup has 12 gauge wire
If ur gonna switch to the 3905 chassis why not get the trans for it aswell
No its not a bad thing ive been removein switches from esc for a long time only thing is when u plug in the batts the truck will power up
Ok so ill bring this one back. So i dumped the brushed setup an went brushless an lipo now my weight has droped by a pound
Not sure realy ive had a few blades get pushed on so far that the motor wouldnt spin but it wouldnt spin at all
Ive found with mine after a crash if u let it sit for a few seconds it starts to work as it should
Didnt see that thanks looks like i got a base startin point
Tires for now will b traxxas sportttrax or the chevron batts i havent bought yet but it will b 4s not lookin for any specfic speed just need a genral starting point for my maxx. The mod 8 5mm bore...
Srry just noticed my mistake the motor is a tt ripper 2000kv
Guess what i should of askes is would a stock trx pinion gear from a revo maxx burshless truck b a good startin point
I looked at that site wasnt much help as it asks for gear sizes but thanks anyway
Hey guys well time has come to go brushless on my emaxx. I picked up a hobbywing sct pro esc an a tt ripper 200kv motor need to get some pinion gears an was wondering what a good starter point mind i...
Ive got 45 in my shocks four red springs an four blue springs love the way it handles.cant realy say what will b best for you but i would say start around 35 an try few diff weights
Rught know with batts im at 10.746 pounds an thats brushed with alum front n rear skid an trx sporttrax tires nimh batts seven cell. Changein just the tires saved alot of weight stock tires are 346...
Just seen the esc an gotta say looks like a rebranded castle hopein it turns out to b a good one