Type: Posts; User: svaldez106
Thanks for letting me know.
I am wondering if anyone has installed any Integy Universal Drive Shafts into a E-Revo. I am looking into replacing my stock drive shaft for Traxxas 7151X Steel Driveshaft Assembly 1/16 E-Revo VXL...
I have just completed this task.
To disable Low-Voltage Detection (NiMH setting):
1. Make sure the LED on the ESC is on and green.
2. Press and hold the EZ-Set button for ten seconds. The LED...
How do I check to see if my ESC is in NiHH mode and not LiPo.
Its about two months old. Is there any other batteries other than lipos that I can get that would give me longer run time?
Does anyone know why I am having this problem?
I am running a single "Traxxas 1200 MAH Power Cell" on my erevo. The battery is fully charged and I am getting less than 5 minutes of drive time. My...
I am wondering what bulkheads are recommended. I thought I read something about the Hot Racing and the Integy bulkheads on this forum but I cant find it.
Thanks guys for your help. I adjusted the toe links and that seem to help.
I have installed Push Rods and Toe Links.
But this is what I have as a result:
One front tire off angle which is outwards
Both of the rear tires are off angle which they are outwards as well....
Thanks guys. If I add the dye to the boiled water in the pot will it mess up the pot.
I am wondering if anybody has tried to dye the RPM arms and is it worth dying from green to black or should I just buy some
black ones. thanks
I was just on this website about fans.
Anybody want to give me feedback from the RPM Steering Blocks or any other steering blocks?
Yes, its worth getting the HR motor conversion kit, but thats my own opinion.
Thank you Jimmie. Yes, I am comparing them.
So, TRA 7014 will replace the part numbers 7092 and 7093. Would that be a good idea to replace it?
Once again thanks.
I am in the middle of taking out my rear. I plan on replacing the suspension arms with RPM and etc. But the thing that I am not for sure to do is the Differential Components.
This is were I am...
Does anyone want to give me some tips on dying the chassis or recommendations.
Does anybody know if I have to buy new push rods and toe links when converting to a slash? Or can I use the toe link (7138x) and push rods (7118x)? Thanks.
Cancel this question because I just...
Thanks for your help.
I know I read a old posting somewhere on this website talking about the conversion. And I am wondering
what I need to convert my erevo to a slash.
Thanks guys for all of your help. So far it is the diff cases were installed wrong. Its probably my fault when I did a deep cleaning to my truck in the winter.
I havent removed 1st and i dont have reverse on the transmission I took it out. Thanks.
It spin with fine going counter clock wise but not clock wise. Thanks alot.
Thanks for your help NathanM and Jay2Play.
How are my differentials up side down? When they are stock and never been touched.
Thats a good thing to know. Thanks