Type: Posts; User: MaxxSavage
From what I can find 4 poles are much more common, only saying that because I can't find anything 2 pole. I guess I'll just invest in a whole new system.
I just bought a used Rustler with the 3350X Velineon system and the motor went out, magnet spinning on rotor. I'm new to the lipo/brushless world. I've been reading about 4 pole and 2...
I dusted off my old Revo this passed weekend and first thing I noticed is it wasn't getting fuel in the carb. Instead of pulling it apart and cleaning it, I just pulled the high speed...
Have you changed the plug yet?
My EZ start wouldn't turn over my 3.3 when it was new. I hooked a 12v bump box battery to the ez start and it worked great.
It's possible your slipper clutch is loose. Does it have good "punch" off the line?
I melted a fuel tank on a truggy from heating from the sides, that's my reasoning for heating from the head :D
5381- Diff housing, gaskets
5416- Front output shaft
5382- Diffential gears
5415- Rear output shaft
If you ask me, I'd buy the center differential set with the FOC conversion. It's...
I'm in Lake Charles. I think I will upgrade, it'll save me $300. I plan to make it just like a platinum. It already has Ti shock shafts, I'm halfway there! But still 2 trucks would be nice. I do have...
I like the idea of swapping parts to the 5309. I also like the fact of having another truck. I'm just not sure if I want to spent the money. 2 trucks are better than one right? haha
It's been a while since I've posted. Its just starting to warm up here in Louisiana and I've been considering going back to my local track. It's been almost a year since I've raced,...
If I can find these I'll be happy to give them to someone.
The head of the bolt could be stripped out and you are feeling the wrench slip.
Tighten the big nut on the spur gear. Sometimes they just loosen up over time.
3.5 gallons is nothing. My first 2.5 exceeded 12 gallons only to fail to the air filter coming off. You have lots of life left in that motor :cool:
I bash! My revo is sitting in my room all muddy. I show it no mercy, I bought it to use!
I've had one way bearings slip to where the roto start, in my case, just free spins and the motor does not turn at all. Not even cleaning the bearing helped. A new one should fix your problem....
If it were installed backwards it wouldn't recoil. It sounds like you need a new one.
Is the one-way-bearing installed?
The new emaxx just said NEXT with water all around it. I think it's gonna be something good, they wouldnt make a big deal out of it if it were just an eslayer IMO.
Yeah, it wouldn't blow the engine. You shouldn't see any problems with that tank with a 3.3
Is the motor not getting close enough or is it too far away?
It sounds to me that you need to adjust your mesh or lack thereof. From your details it seems like you should slide the motor towards the spur gear.
The 4 screws and the pipe mount screw removes the motor. Make sure you get the throttle stud out of the bellcrank so you don't break anything. It's also a good idea to connect the fuel line to the...
I honestly do not trust anyone but myself when it comes to working or tuning my cars. There is a good possibility your LHS ran it "too hard" or something along the lines of that.
I do agree with...