Search:

Type: Posts; User: Fitness14

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    150

    Reset transmitter to defaults.

    Reset transmitter to defaults.
  2. Replies
    7
    Views
    261

    Stock is 23 86. I went to 21 86 for more dirt...

    Stock is 23 86. I went to 21 86 for more dirt throwing torque and acceleration as well as better run time. For me it is the sweet spot. Do not need more top speed as I strictly bash.
  3. Replies
    10
    Views
    240

    It can be tricky...the mesh can tighten up a bit...

    It can be tricky...the mesh can tighten up a bit when you tighten the motor screws. Try this: loosen the motor screws just enough so the motor will swivel a little. Then set your mesh by sliding...
  4. Thread: Gearing

    by Fitness14
    Replies
    6
    Views
    164

    23/86 is stock for brushless. 18/86 is...

    23/86 is stock for brushless. 18/86 is fine......you are already geared down from stock. I have ordered a 21 T pinion just because I want more acceleration and run time.
  5. Thread: Hex Drivers?

    by Fitness14
    Replies
    11
    Views
    257

    https://upload.wikimedia.org/wikipedia/commons/1/1...

    https://upload.wikimedia.org/wikipedia/commons/1/1c/Torx-Bits_T15-T20-T25-T30.jpg

    No more stripped hexes.
  6. Replies
    9
    Views
    271

    Also, when I removed my gear cover it looked like...

    Also, when I removed my gear cover it looked like the mesh between the pinion and spur gear had separated slightly. So I reset the mesh getting it nice and tight, and then backing it up just a hair....
  7. Replies
    9
    Views
    271

    I had the same thing. I cleaned the axles well...

    I had the same thing. I cleaned the axles well and checked everything, including pinion spur, etc. First heard the noise at a gravel pit...:p Then I was obsessing after that thinking I still...
  8. Replies
    21
    Views
    1,219

    Go 4X4. I have the 2wd (technically my...

    Go 4X4. I have the 2wd (technically my kids...but I drive it when they are asleep!) which I love, but I would like better acceleration in grass and the ability to not get stuck off roading like...
  9. I am by no means an expert, just a guy who...

    I am by no means an expert, just a guy who started with a stock slash 2wd vxl and decided to get the best suspension performance I could without buying any aftermarket parts. I read a lot online...
  10. Replies
    6
    Views
    1,790

    I run 8mm bullets. I like them.

    I run 8mm bullets. I like them.
  11. Replies
    8
    Views
    911

    I have given up trying to keep it looking like...

    I have given up trying to keep it looking like new. I just brush off the shocks, clean out mud from under the a arms where it can get jammed under the skids, and also brush between the hubs and the...
  12. Do they fit the revo without mods?

    Do they fit the revo without mods?
  13. Replies
    13
    Views
    1,487

    Exactly. Throttle control is not only better for...

    Exactly. Throttle control is not only better for the truck, but produces better performance. It is really win win.
  14. Replies
    13
    Views
    1,487

    ERBE: Tough as nails

    I just wanted to balance some of the info people must get from the web as far at this kits durability. I run 6s hyperion G3 VX 5000 mah batteries and have found the truck to be exceedingly durable...
  15. Replies
    700
    Views
    238,700

    Rather than start a new thread.... I have...

    Rather than start a new thread....

    I have taped a few set of tires. The tape ultimately failed. The tires started balooning again. One set is still fine to drive, but I basically ruined a set...
  16. Replies
    16
    Views
    1,255

    I run my E revo hard on crushed rock and rough...

    I run my E revo hard on crushed rock and rough terrain. That sandblasted look to the bottom is normal unless you run on the street and grass only. I have come to find worn and dirty...
  17. I just blew my first diff. the rear of course. ...

    I just blew my first diff. the rear of course. I opened her up and a bearing blew, which allowed the pinion to slide in ad out, which deformed the teeth on the pinion itself and the ring gear. I...
  18. Replies
    6
    Views
    1,798

    Thanks guys. I will try the square knot and a...

    Thanks guys. I will try the square knot and a touch of ca glue.

    Does acetone ruin the tires or rims in any way?
  19. Replies
    6
    Views
    1,798

    Taping tires warning and kevlar line

    I have taped two sets of mashers and one set of badlands. I used a "fiber" type duct tape but it was maybe too stretchy and not thick and stiff enough. I think I did a good job taping, but over...
  20. Thread: wheel wobble

    by Fitness14
    Replies
    10
    Views
    1,230

    Right on. Cleaning and maintenance is a basic...

    Right on. Cleaning and maintenance is a basic part of this hobby. But I must say that my experience has been that the E-revo is a very tough truck stock. If a person drives with some skill and...
  21. Thread: wheel wobble

    by Fitness14
    Replies
    10
    Views
    1,230

    They will all wobble eventually. Heck, I got...

    They will all wobble eventually. Heck, I got duck tape over chassis holes where rocks get in the battery box, duck tape under the chassis where the battery doors hinge is (it was cracked), dremel...
  22. Thread: wheel wobble

    by Fitness14
    Replies
    10
    Views
    1,230

    It develops from normal usage. I have it and I...

    It develops from normal usage. I have it and I used to worry about it until I realized that a little play is inevitable and sometimes advantageous. It drives great, so I don't sweat it. Don't...
  23. Thread: Sway bar kit

    by Fitness14
    Replies
    8
    Views
    1,215

    One of the biggest mistakes IMHO is too throw on...

    One of the biggest mistakes IMHO is too throw on stiff springs to "land big jumps", because what you get is a truck that maintains a higher ride height while cornering and thus flips easier. You...
  24. Replies
    18
    Views
    5,679

    6s...correct gearing.....trigger control....= FUN

    6s...correct gearing.....trigger control....= FUN
  25. Replies
    15
    Views
    1,147

    I have read a lot about the e revo brushless not...

    I have read a lot about the e revo brushless not handling 6s....but I have found that to not be the case. I have been running Hyperion 6s 5000 mah (45-90c). These batteries are powerful. I have...
Results 1 to 25 of 53
Page 1 of 3 1 2 3