Search:

Type: Posts; User: GSKSP1

Page 1 of 9 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    5
    Views
    437

    lol nothing to worry about untill the pinion gets...

    lol nothing to worry about untill the pinion gets so loose from all the torque that the bearings fall apart inside the diff case, then your replacing about everything but the gears inside the diff.
    ...
  2. Replies
    23
    Views
    1,283

    I bought 2 sets of Venoms when I bought my...

    I bought 2 sets of Venoms when I bought my maxx...3905. both sets blew up. now this is when i had the molex on my charger and batts. I swore to never buy another set. until I was up at my lhs and...
  3. Replies
    16
    Views
    1,415

    I agree with that statement...way too much slop...

    I agree with that statement...way too much slop for a hobby grade RC

    When I got my truck a year and a half ago, my servos were fighting each other for center..blew both of them out within a...
  4. Replies
    7
    Views
    623

    Yea, I cant believe the price of the...

    Yea, I cant believe the price of the slayer..still too expencive. not a real hot seller.
  5. Replies
    4
    Views
    583

    If you switch to a single setup on the EVX2 you...

    If you switch to a single setup on the EVX2 you have to re-wire the motor leads...you have to wire 2 red wires on the positive leg and then 2 black wires on the negative leg of the motor.

    This...
  6. Replies
    2
    Views
    489

    I've had my summit for about 7 months I...

    I've had my summit for about 7 months I think...Just about all my bearings are shot. Already had to replace the Diff Pinion bearings...one blew out and the little balls went everywhere in the diff...
  7. I had some issues with him on steel drive shafts...

    I had some issues with him on steel drive shafts for my e-savage I had. he sent me the wrong size...well actually the company that made them for him to sell made them too long. After many emails...
  8. Thread: "smoked" motor?

    by GSKSP1
    Replies
    4
    Views
    617

    yep, sounds like it. I try not to keep the...

    yep, sounds like it.

    I try not to keep the throttle full while in grass or snow..only in short bursts. These motors just cant take it..brushed that is.
  9. Replies
    13
    Views
    701

    lol im afraid of jumping off a 1ft jump with my...

    lol im afraid of jumping off a 1ft jump with my summit. To each their own tho right? I'm always happy seeing someone break their truck. Cause its not mine :D
  10. Thread: New ESC

    by GSKSP1
    Replies
    3
    Views
    861

    Owners manuals are your friend.

    Owners manuals are your friend.
  11. Replies
    6
    Views
    593

    The rear was probably replaced...thats the one...

    The rear was probably replaced...thats the one that broke for me. The front hasnt yet, but I'm sure it will. Traxxas sent me 2. Still have one for the front.

    The ones Traxxas sends are the new...
  12. First thing, never run your batteries completely...

    First thing, never run your batteries completely out. Its not good for your batt's.

    Secondly, I notice that...lets say I run only about 8 minutes out of a battery and the next day recharge them,...
  13. Thread: E-Maxx 3905

    by GSKSP1
    Replies
    15
    Views
    1,660

    Ditch the Venom batteries...You may have run...

    Ditch the Venom batteries...You may have run Venoms before, however this big truck draws alot amps and power from the batt's. Those Venoms dont have their tabs soldered...they are pressed on. ...
  14. Replies
    7
    Views
    1,668

    they all fry

    they all fry
  15. Replies
    45
    Views
    3,210

    E-maxx is NOT a better basher than well...just...

    E-maxx is NOT a better basher than well...just about any other truck. The suspension is plush, but not even close to being good enough not to bottom out the truck. You have to buy upgrades for the...
  16. Replies
    10
    Views
    1,191

    You can tell by the smell of the motors if you...

    You can tell by the smell of the motors if you ran them too far into the heat thing. Believe me when I say after about a year or so of running burshed motors, you'll be able to tell when a motor is...
  17. Replies
    16
    Views
    817

    I dont know what in your motor would squeek. Its...

    I dont know what in your motor would squeek. Its probably not your motor.

    Try throwing some WD40 or equivalent down your hing pins. Thats where mine squeeked. :D
  18. Thread: No low range

    by GSKSP1
    Replies
    23
    Views
    3,275

    make sure that your linkage is hooked up. if it...

    make sure that your linkage is hooked up. if it is...probably a bad servo, or bad switch on your TX.
  19. Replies
    4
    Views
    246

    you cannot mix and match..well you can but you'll...

    you cannot mix and match..well you can but you'll drain your lower mah cells before the higher ones are drained. Eventually you'll ruin all your cells.

    Just an FYI all of us can read non-Capped...
  20. Replies
    0
    Views
    239

    Back up and running!

    Well, got my Summit back up and running. Replaced the broken gear.

    Had a crap load of rain to day, enough to make a pond of my back yard.

    This was only the 4th time running it. wasnt even...
  21. Replies
    12
    Views
    554

    I got mine 2 days after I called them. I asked...

    I got mine 2 days after I called them. I asked for 2 of them for when my rear one breaks. I got 2 :D I do like the customer support.
  22. Replies
    14
    Views
    761

    Lets be fair to Venom. When the 3905 came...

    Lets be fair to Venom.

    When the 3905 came out, I bought a set of 6 cell 3600 venoms. Blew the caps off of both after 5 runs. I kept the packs..dont ask me why. I was up at the LHS a month...
  23. Replies
    12
    Views
    554

    Yep, 6-7 days old. This was my 3rd time running...

    Yep, 6-7 days old. This was my 3rd time running it.
  24. Replies
    12
    Views
    554

    I dont know what I did

    as the title says....it broke, the 5678 part. Wasnt climbing, wasnt in low gear. I just noticed something was wrong. Front tire spinning freely from all the rest no matter what gear or "lock" I...
  25. Replies
    18
    Views
    601

    I gotta tell ya, I drive my E-Maxx like it was...

    I gotta tell ya, I drive my E-Maxx like it was made of glass. When you read the articles that Traxxas says its the toughest maxx yet...bleh.

    I know that when I hit something, there's breakage...
Results 1 to 25 of 206
Page 1 of 9 1 2 3 4