Type: Posts; User: bde742
those look nice. please post results!
drill a small hole and put a screw in it. http://i163.photobucket.com/albums/t301/bde742/oRCo/krissy072.jpg
not every kid watches this. i'm talking about hitting a bigger market. the junk cars advertise on channels watched by kids. that way the kids can pester their parents. my house runs lipo. but, i'm...
You guy's rock!What a great release. The only question now is which one? But let me paint you a picture....... It's Chrismas morning in a quiet little town. A 7 year old boy is opening his first ever...
i run mashers. actually on my second set. yes gear it around 14/86 or 90. keep the slipper adjusted correctly and you should be fine.http://i163.photobucket.com/albums/t301/bde742/Temp009.jpg i run...
check your pinion gear
masher 2k's and axial beadlocks!
proline protoform ort truck body. stock suspension with masher 2k's on axial beadlocks. i gorilla taped the inside of the tires, and used plasti dip on the lock rings to keep...
if you can turn it by hand it is probably toast.
were the leads ripped off while the motor was connected to the esc? do you still have the stock motor to test with?
worn bearing carriers will cause wobble a well
it sounds like battery damage. you should be getting more than 7.4v. my 3s charges to around 12.6v
do you balance when you charge? did you use an after market lvc on the stock setup? are you sure it's lvc and not thermal shutdown?
if you haven't replaced the sliding drive shafts yet, you should pick up a set. that was the first thing that let go. they wear out, not really a big deal. it wasn't till 3s that i really broke...
try putting tape on the inside of the tire?
i ran a trinity monster maxx pro (before i went brushless). loved that motor. just keep bearings around if you run wet conditions
i charge 7 cells with mine. thought it was rated op to 7 cell batteries. mine is for sure (just looked)
all you need is a large washer. i've made two of them. they do help
check to see if the steering cranks popped out of the hole that keeps them in place. this has been a very common problem.
get the new ones for the 4x4 slash
I've run sway bars for well over a year now. All i do is bash. all the reasons bars are used in racing, occur in a good bash session. a good set of bars will absolutely improve performance.
are you a basher or a racer? I don't race so, my best addition was masher 2k tires on axial beadlocks.
just get a set of beadlocks. paint the back of your lock rings with plasti-dip. I run masher 2k's on axial beadlocks with a vxl on 3s lipo. when you take off the tire the plasti-dip will peel right...
the fans work. they also stop working very quickly. $20 is alot to pay for as fast as they break.