Type: Posts; User: Trevdawg
Now I got the 2.5/3.3 kit for my rustler!! It will be a fun spring!!!
With just cleaning. Should I still get a new head gasket or anything??
With cleaning it out, do you just wipe/clean it with WD40 inside or do you do anything else?
Neat. I want to get mine going so bad
Agreed. You know of any good hobby shops in this area?
I do want to upgrade. My main concern is getting this jato going, Needs new upper and lower bulk and suspension.
Then I will fix this rustler. But I have to get the adapter kit to fit a...
Should I just disassemble, clean and re assemble???
Or get a new piston and sleeve, head gasket???
Rebuild the front end of my jato to get going.
Rebuild my .15 rustler motor
Well now you tell me. :)
So I have an old 1.5 rustler. It has been past its prime but still runs. I can only get a few good runs out of it before I retired it for the past few years.
I have loosened it up and it cranks....
Got the 3.3 to rotate now. .... Just letting them sit lubed up and will start to fix the front end of the jato after the holidays.
Well I did put the "after run" lub last night in the carb, chamber, exhaust port. Then this morning put wd40 in the same spots and it is all good. It took some muscle but now it turns freely.
The 3.3 is still stuck. I will try the wd40 and see where it goes
I mean this thing was brand new and barely used ... Literally.
I used this "after run" lub because it is suppose to help prevent, break down any corrosion and my 1.5 (which has been...
My RC car has been sitting for a couple years. I want to fix the chassis and get it going again so it will be ready for spring. It is a jato 3.3 and is brand new. We broke it in like the manual said....
Helpful. I will do this once I get mine running
Mine hasn't been running for years. It will be interesting if I can get them going.... A 3.0 and 1.5 motor(s)
Never mind. Found it
I don't see the kit but I do see the engine mount.
Tower hobbies seems to have a kit to change gearing but... I will continue looking.
Is there anything else I should change in regards to...