Search:

Type: Posts; User: Team Derp

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    11
    Views
    704

    We are using Traxxas Top Fuel 20% for our TMaxx....

    We are using Traxxas Top Fuel 20% for our TMaxx.

    We put in the new carb that Traxxas sent us and it made no difference. We thought back to an issue we had posted about in the past before we...
  2. Replies
    11
    Views
    704

    I responded with the wrong stuff, I meant to say...

    I responded with the wrong stuff, I meant to say Richen.. Tried playing with both, richening the HSN and LSN, no difference. Havent had anytime to even drive the truck or the brand new Revo we got....
  3. Replies
    11
    Views
    704

    We tried playing with the LSN some, maybe will...

    We tried playing with the LSN some, maybe will lean it out a bit more. We didn't want to run it too much, with it acting up.

    Would a brand new engine seriously have air leaks? The rest of the...
  4. Replies
    11
    Views
    704

    3.3 T-Maxx - Creeps During Break-In

    I recently swapped out my old 3.3 that was well worn for a new on one my T-Maxx. When we put the engine on the truck, and went to break it in, it idled extremely high and only had it running for a...
  5. Replies
    9
    Views
    183

    Try a different remote.. Mine was twitching due...

    Try a different remote.. Mine was twitching due to a bad remote. Got a new one and fixed issue. See if you can borrow one to avoid buying one. If that doesnt fix it, try receiver.
  6. Replies
    9
    Views
    183

    Our resurrected 3.3 TMaxx went WOT into a ditch...

    Our resurrected 3.3 TMaxx went WOT into a ditch last week due to radio interference. Luckily, it was going fast enough to jump the 6ft ditch and land on the embankment.
  7. Can you clarify what you mean by "ez starter will...

    Can you clarify what you mean by "ez starter will then get what feels like hydro lock".

    If it is flooding, it sounds like you're running it rich and need to lean it out. I have the EZ-Start for my...
  8. Truck ran pretty good today.. It stalled a time...

    Truck ran pretty good today.. It stalled a time or two, but may just bin the tune as it started right up.

    Ripped off the tank tonight, no leaks. Will check carb for leaks tomorrow.

    Also putting...
  9. I will give it a whirl. I did re-tighten the carb...

    I will give it a whirl. I did re-tighten the carb down as it was not as tight as it could be. Will check it all :)
  10. LHS was closed.. Stole the clutch shoes/springs...

    LHS was closed.. Stole the clutch shoes/springs from another engine. Will run it later on and see whats up.

    What do you suggest for checking for air leaks?
  11. Picking up the clutch shoes and spring today and...

    Picking up the clutch shoes and spring today and cleaned the OWB so we can run it today and re-tune it some. I will try leaning out the LSN some more, it may still be running a little rich on the HSN...
  12. Replies
    3
    Views
    285

    I would be interested in the EZ Start for the 3.3...

    I would be interested in the EZ Start for the 3.3 for sure.

    As well as the wheels (Got a pic?) and possibly the bumpers and skid plates. What is the bumper mounts your referring to?
  13. T Maxx 3.3 restarting, stalling, and OWB issues

    We have been working hard recently trying to get our T-Maxx with 3.3 up and running. For days, we have thought that the engine was toast. We had been able to get the truck started just fine when it...
  14. Replies
    39
    Views
    456

    First time I flew my plane, it was going awesome...

    First time I flew my plane, it was going awesome till a gust of wind came and threw it in a tree... Same with the helicopter, it was great a few flights, 3 weeks into having it, a draft came out of...
  15. Replies
    5
    Views
    844

    Swapped over the POT and wala! It works. :)

    Swapped over the POT and wala! It works. :)
  16. Replies
    13
    Views
    283

    Ah Ok. Good to know. Its got 2056 for the...

    Ah Ok. Good to know. Its got 2056 for the throttle as well. I was confused there :)
  17. Replies
    41
    Views
    644

    Drill a small hole where the OWB is on the pull...

    Drill a small hole where the OWB is on the pull start? I've seen people do it for the EZ Starts.

    Its not always cold when it won't start though. When I got it running last night, I was doing a few...
  18. Replies
    41
    Views
    644

    I am most likely going with this. I also see...

    I am most likely going with this. I also see offers with the gear only, is that just replacement gear?
  19. Replies
    13
    Views
    283

    Wouldn't the 2018 be the stock servo? I also...

    Wouldn't the 2018 be the stock servo?

    I also saw your in Cocoa. We are in Melbourne.
  20. Replies
    41
    Views
    644

    Since the reverse servo is pulled anyways, I am...

    Since the reverse servo is pulled anyways, I am most likely going to do this. I can always swap back if I want reverse.
  21. Replies
    41
    Views
    644

    It is most definately opening 100%. After going...

    It is most definately opening 100%. After going back out again (@ nearly 1AM), I was able to get it to run pretty decent.

    I am having one major problem though that if I could resolve, I could...
  22. Replies
    41
    Views
    644

    For some reason, I could not think of that...

    For some reason, I could not think of that verbiage. I am going to replace it the weekend and fix that for sure.
  23. Replies
    41
    Views
    644

    So tried to tune the truck but having issues. ...

    So tried to tune the truck but having issues.

    Sometimes the truck just sits there and the spur gear spins and the truck goes nowhere util your at like 70% throttle and it just goes into a jerking...
  24. Replies
    13
    Views
    283

    They arent the stock. They are the 2056

    They arent the stock. They are the 2056
  25. Replies
    13
    Views
    283

    I noticed on the one I just got, if its sitting...

    I noticed on the one I just got, if its sitting still on the ground the wheels will not turn, but once in motion, no issues steering. I just think its due to the big tires and gripp that gives the...
Results 1 to 25 of 45
Page 1 of 2 1 2