Type: Posts; User: peeweedogue
Probably just one layer. You may have to narrow the width of the tape though. Because the tape is so thick it will cause the sidewall of the tires to be deformed or out of shape if you don't cut...
DO NOT BUY THAT !!!!
I purchased that and it lasted about 5 minutes. It's a total waste of $$$$
When you said this:
"I just broke my stock plastic rear hub on my slash 4x4"
I thought you were talking about these:...
I can't speak for other 1/8 adapters but if you buy these:
then you don't...
Not to be smart, but, aren't Nike's made overseas w/child labour ?
Not sure the % but I believe New Balance are made in the USA
I'm Canadian but that's the only shoe I'll ever buy (gr8 fit, gr8...
(1-2-3) you don't need hubs if you buy 17mm adapters
I have hardcased lipos with bullet connectors. I put a dab of silver permanent marker on the + side of the batteries. It would be very easy to reverse the connections. Actually maybe I should have...
I had a really good reply all typed out... but honestly... I just gave you "my good mood" version. I didn't want to get any warning % points from the mod's. Have a nice day.
I will assume you`re just kidding !
YOU !... might wanna` also state that the OP has a limit of 5400mah
I'm not sure where you got your #'s from but...
Canadians only pay 5% tax and...
Thanks for the help guys, I appreciate it !!!!!!!!
Would the green colour 3m tape be ok ? I have a few rolls in different widths already. Or is the blue colour preferred ?
To some this may seem to be a stupid question, but here goes. What different types of masking tape will work when painting a new body ? These are what I have previously purchased:
you could go this route also
If the shaft spins fast enough to put grease (thick) to the side of a bearing then what will happen to oil (thin) ? Wouldn't the oil would probably get thrown past the seals... ?
I normally don't comment on people's paint jobs; not because I don't like them, I just don't take the time to do it. But that paint job is very nice !!!
RTR is 50 / 40
it's in the manual
these will work
2.2 / 3.0 - http://prolineracing.com/wheels/split-six-2.2/3.0-black-one-piece-wheels/
or 1/8 buggy's -...
Perhaps people are tightening the 4 diff. carrier screws down too much...???
2.2 wheels will not fit. I believe some guys have got a 2.2 RPM wheel (not sure which one) to fit with a lil`dremelling. There are at least 15 posts on this topic. The info you want shouldn`t be...
I love the flat black look, what type of paint is it ? Tamiya, Pactra, ??? Rattle can or airbrush ? Thanks for any help !