Type: Posts; User: svaldez106
The original problem was it wasn't shifting into gear and I am still trying to figure that out.
Thank you. I was able to figure it out last night. After posting what spins and doesn't. But now I am just trying to get a good tune so it can run longer than 30-45 seconds.
Here's what spins clutch Bell, flywheel, spur gear, input shaft and out put shafts but the axles does not spin.
However today when I was messing around with it the motor only would stay on for a...
It's forward only. I am able to start the engine but I can not get the wheels to spin. I have tried tuning and still can't get it to be perfect.
I have my Tmaxx. I have rebuilt my transmission but it will not shift into gear. Can someone help me, please.
Hey guys, i am wondering when building the transmission should I put some oil in the transmission? If so, what grade?
Thanks for letting me know.
I am wondering if anyone has installed any Integy Universal Drive Shafts into a E-Revo. I am looking into replacing my stock drive shaft for Traxxas 7151X Steel Driveshaft Assembly 1/16 E-Revo VXL...
I have just completed this task.
To disable Low-Voltage Detection (NiMH setting):
1. Make sure the LED on the ESC is on and green.
2. Press and hold the EZ-Set button for ten seconds. The LED...
How do I check to see if my ESC is in NiHH mode and not LiPo.
Its about two months old. Is there any other batteries other than lipos that I can get that would give me longer run time?
Does anyone know why I am having this problem?
I am running a single "Traxxas 1200 MAH Power Cell" on my erevo. The battery is fully charged and I am getting less than 5 minutes of drive time. My...
I am wondering what bulkheads are recommended. I thought I read something about the Hot Racing and the Integy bulkheads on this forum but I cant find it.
Thanks guys for your help. I adjusted the toe links and that seem to help.
I have installed Push Rods and Toe Links.
But this is what I have as a result:
One front tire off angle which is outwards
Both of the rear tires are off angle which they are outwards as well....
Thanks guys. If I add the dye to the boiled water in the pot will it mess up the pot.
I am wondering if anybody has tried to dye the RPM arms and is it worth dying from green to black or should I just buy some
black ones. thanks
I was just on this website about fans.
Anybody want to give me feedback from the RPM Steering Blocks or any other steering blocks?
Yes, its worth getting the HR motor conversion kit, but thats my own opinion.
Thank you Jimmie. Yes, I am comparing them.
So, TRA 7014 will replace the part numbers 7092 and 7093. Would that be a good idea to replace it?
Once again thanks.
I am in the middle of taking out my rear. I plan on replacing the suspension arms with RPM and etc. But the thing that I am not for sure to do is the Differential Components.
This is were I am...
Does anyone want to give me some tips on dying the chassis or recommendations.
Does anybody know if I have to buy new push rods and toe links when converting to a slash? Or can I use the toe link (7138x) and push rods (7118x)? Thanks.
Cancel this question because I just...