Search:

Type: Posts; User: wvaughn7

Page 1 of 6 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    14
    Views
    463

    You will not have to take it completely apart but...

    You will not have to take it completely apart but it is easiest if you will remove the piston and sleeve. The picture above is an extreme example. If the top of the piston can be pushed past the top...
  2. Sorry the 3 channel radio system sold locally...

    Sorry the 3 channel radio system sold locally earlier today and I haven't had the chance to update this thread. The Tqi transmitter is now also sold.
  3. Replies
    4
    Views
    184

    You can install a forward only conversion kit...

    You can install a forward only conversion kit which eliminates the shift servo and reduces the rotating mass in the transmission considerably. The kit is a Traxxas part and has straightforward...
  4. Replies
    16
    Views
    6,033

    The 3.3 is the biggest engine made by Traxxas,...

    The 3.3 is the biggest engine made by Traxxas, but there are many engines that will bolt right in to a T-Maxx. Most small block engines will fit along with a couple of larger engines.
  5. Will take 30 shipped for entire EZ-Start system.

    Will take 30 shipped for entire EZ-Start system.
  6. Thread: T Maxx 3.3

    by wvaughn7
    Replies
    5
    Views
    1,156

    Your vehi0cle could have lost connection with...

    Your vehi0cle could have lost connection with your transmitter and caused it to go to WOT or a linkage could have came loose or broke. Check over the vehicle and see if the radio will control the...
  7. Replies
    17
    Views
    382

    You may also the old Pro .15 engine which is a...

    You may also the old Pro .15 engine which is a 2.5cc engine, but it used a smaller metal carb than the newer plastic ones. I don't know if this is your problem but it's something I would make sure...
  8. Bump to the top

    Bump to the top
  9. Replies
    8
    Views
    1,703

    For any of you all that don't know Rex Welch from...

    For any of you all that don't know Rex Welch from RW Mods will also repinch sleeves. I have had both him and Ray do a sleeve for me and their work is very comparable. The good thing is Rex only...
  10. Replies
    1
    Views
    130

    Anything has to be better than the stock springs...

    Anything has to be better than the stock springs or big bore springs either one in my opinion. The progressive springs have pretty good reviews among the few people I know that have them, but for...
  11. Replies
    18
    Views
    859

    Regardless of if it's stuck at TDC or not you...

    Regardless of if it's stuck at TDC or not you always need to rotate the piston to BDC when you kill the engine for the day. It allows everything to cool and shrink back down the original size, and...
  12. Replies
    18
    Views
    859

    Ok you at least know the engine isn't locked up...

    Ok you at least know the engine isn't locked up causing it to not be able to turn. Can you try to take the ez start off to make sure the motor and gears will spin when power applied with no load? If...
  13. Replies
    18
    Views
    859

    Can you turn the flywheel by hand?

    Can you turn the flywheel by hand?
  14. Replies
    5
    Views
    233

    Each channel on the radio system is independent...

    Each channel on the radio system is independent of the other channels. You can reverse the steering without altering the throttle or reverse servo if you truck has one equipped.
  15. Replies
    13
    Views
    365

    The newer trucks have a failsafe built into the...

    The newer trucks have a failsafe built into the radio system that returns the throttle servo to idle when the battery gets too low or if there is a los of connection between the transmitter and...
  16. FS: Traxxas EZ-Start 2 wand, motor, battery and wires

    I have a slightly used EZ-Start 2 system that was pulled from a T-Maxx 3.3 in favor of a pullstart. Everything works fine and has only a couple marks on the wand itself. The only thing you will need...
  17. FS: Traxxas EZ-Start 2 wand, motor, battery and wires & Traxxas radios

    I have a near new 3 channel TQI transmitter that came off of a T-Maxx 3.3. The radio was used a couple times and has only a slight scuff mark on the back. I already had another radio to link to the...
  18. Replies
    2
    Views
    315

    Yes the lower the count on the clutchbell the...

    Yes the lower the count on the clutchbell the better torque/less top speed you will have. On the spur it works just the opposite. A two tooth defference on the bell should be pretty noticable.
  19. You learn something every day haha. I just...

    You learn something every day haha. I just figured it helped keep the heat away from the fuel line right over the header.
  20. I haven't used it but hear good things from...

    I haven't used it but hear good things from people that have. The only thing I find bad about it is that if you have plastic gears in the transmission they will strip instead of the spur. You will...
  21. If you are barely melting the heat shields it may...

    If you are barely melting the heat shields it may not be too bad, but if they are melting quickly after starting it you may be a little lean. I know you may seem tuned correctly as I did when I first...
  22. Stock hubs on a maxx are only 14mm, This means...

    Stock hubs on a maxx are only 14mm, This means you would need the new nuts, hubs and also completely different wheels. Many people will upgrade to the 17mm hex because it helps avoid stripping due to...
  23. I just wish my maxx would do wheelies period...

    I just wish my maxx would do wheelies period haha. Stupid little Megatech M16 must have half a horsepower. I have even geared down to 17/72 on the black tranny and it still won't pop a wheelie. Guess...
  24. Replies
    29
    Views
    1,030

    I would use the ARO unless you know for certain...

    I would use the ARO unless you know for certain it will be ran in a day or less. Even if you just think it will be ran later I would go ahead and do the after run procedure, because if you happen to...
  25. Replies
    24
    Views
    1,343

    I've never used it personally, but for the money...

    I've never used it personally, but for the money I have heard great things about the Novarossi N21B. It's just their basic .21 3 port engine, but at only $167 from amain it's not a bad deal.
Results 1 to 25 of 132
Page 1 of 6 1 2 3 4