Search:

Type: Posts; User: Tirider

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    13
    Views
    584

    http://monster.traxxas.com/showthread.php?t=387085

    http://monster.traxxas.com/showthread.php?t=387085
  2. Thread: airbrush

    by Tirider
    Replies
    10
    Views
    616

    This is what I used:...

    This is what I used: http://www.iwata-airbrush.com/products/airbrush/eclipse/hpcs_info.jsp

    To Paint This:
    http://i151.photobucket.com/albums/s128/tirider/Mugen2.jpg

    My first attempt at...
  3. Thread: Fresh Paint

    by Tirider
    Replies
    4
    Views
    497

    Thanks! Ti

    Thanks!

    Ti
  4. Thread: Fresh Paint

    by Tirider
    Replies
    4
    Views
    497

    Fresh Paint

    I bought an airbrush and here is my first attempt. No, it ain't a REVO as my REVO body is holding up so far. Thoughts??

    http://i151.photobucket.com/albums/s128/tirider/Mugen1.jpg
    ...
  5. Replies
    9
    Views
    491

    15/40 is a good start. A little more low end can...

    15/40 is a good start. A little more low end can be achieved with a 14/38. Anything lower and you start to lose noticeable top-end speed. a 14/40 would be hard to control but maybe good for tight...
  6. Thread: rear brake

    by Tirider
    Replies
    18
    Views
    608

    I have not had issues with my rear brake Ti

    I have not had issues with my rear brake

    Ti
  7. Replies
    7
    Views
    349

    If there is no pressure from the exhaust nipple...

    If there is no pressure from the exhaust nipple it might be wise to remove the exhaust pipe and verify that the pressure nipple is not blocked. You can do this by plugging the stinger and...
  8. Replies
    31
    Views
    921

    Yes, off road you get a lot of dirt all over your...

    Yes, off road you get a lot of dirt all over your truck.

    Ti
  9. Replies
    7
    Views
    441

    J.A.T.O.3.3 I got them March 2007. They came...

    J.A.T.O.3.3
    I got them March 2007. They came with four rings that go inside the wheel to hold the tire bead in. I assembled them very carefully making sure I had the tire bead captured completely....
  10. Replies
    7
    Views
    441

    I have a set of Maximizer Beadlocks with Crime...

    I have a set of Maximizer Beadlocks with Crime Fighters mounted up. They are similar to 1/2 offset and make the truck about as wide as a 40 series tire. I raced with them and have had some issues...
  11. Replies
    2,131
    Views
    442,518

    Sticky: Updated Set-ups

    Hey, anybody have an updated set-up for a truck similar to mine.

    2.5 chassis, .18TM with Trinity pipe, Tekno extended rear arms, center diff & rear brake, FOC, Tekno wing, batt. box w/mugen MBX5T...
  12. Thread: Very Bad Day

    by Tirider
    Replies
    31
    Views
    1,013

    A well tuned truck would not have a burned, black...

    A well tuned truck would not have a burned, black topped piston like the one in the picture. YIKES!
  13. Replies
    4
    Views
    373

    Foams, tires and wheels are brandy new. No wet...

    Foams, tires and wheels are brandy new. No wet foams
  14. Replies
    4
    Views
    373

    Wheel Balancing

    I am surprised at the amount of material it takes to balance a Maxx size tire and dish wheel combo. How can the assembly be so out of balance in one area?

    Ti
  15. Thread: stingers tube

    by Tirider
    Replies
    5
    Views
    332

    The oil will build-up at idle but get blown out...

    The oil will build-up at idle but get blown out when throttle is applied. I would recommend keeping it turned down.
  16. Replies
    4
    Views
    324

    Bump - Anyone?

    Bump - Anyone?
  17. Replies
    4
    Views
    324

    Slipping FLYWHEEL

    I recently installed the larger (40mm) Traxxas flywheel for a starter box. The darned thing started slipping and giving me all kinds of fits. Enough to make me think I blew my engine (earlier...
  18. Thread: paint jobs

    by Tirider
    Replies
    25
    Views
    973

    This paint job was completed with masking tape...

    This paint job was completed with masking tape and three cans of paint. Red, Orange and Yellow. The fade from red to orange is a little hard to see but it looks good in sunlight. Simple and...
  19. Replies
    10
    Views
    549

    Atomic: Thanks, good ideas. If I can't pinch it...

    Atomic: Thanks, good ideas. If I can't pinch it I will get the new piston and sleeve. All internals are clean and in good shape.

    I3asher: I got my money's worth out of this motor. I wouldn't...
  20. Replies
    10
    Views
    549

    Hey Atomic, The piston won't travel through...

    Hey Atomic,

    The piston won't travel through the top of the sleeve after being removed. Is there hope for this motor? It was definately losing compression out the bottom of the sleeve/piston...
  21. Replies
    10
    Views
    549

    Thanks all! It was an 18tm that was a couple...

    Thanks all!

    It was an 18tm that was a couple of years old. I decided to buy a new one because I have a race next week and can't afford to bumble a new piston and sleeve having never done the...
  22. Replies
    10
    Views
    549

    Is My Engine Blown?

    A confirmation please...

    Motor started making an odd noise then it would run but only with throttle. Felt like a little less compression than usual so I took off the header and looked inside...
  23. Thread: Need Help!!!

    by Tirider
    Replies
    7
    Views
    215

    Based on your criteria, fun and jumping yet...

    Based on your criteria, fun and jumping yet competitive on the track... you can't go wrong with the REVO. Buggies are purpose built for the track but can be fun off track. The REVO is built for off...
  24. Thread: upgrades!!!

    by Tirider
    Replies
    12
    Views
    443

    The Slayden steering mods are free and enhance...

    The Slayden steering mods are free and enhance performance if you run on a track. Check the traxxas site.

    Ti
  25. Replies
    10
    Views
    357

    I run the Trinity with the 18TM and have been...

    I run the Trinity with the 18TM and have been very pleased with it. No experience with the THS pipe. One nice thing about the Trinity pipe is that I can hear what my truck is doing over all the...
Results 1 to 25 of 87
Page 1 of 4 1 2 3 4