Search:

Type: Posts; User: got_nitro

Page 1 of 20 1 2 3 4

Search: Search took 0.26 seconds.

  1. Replies
    14
    Views
    842

    I don't have a pic but i could get one up if you...

    I don't have a pic but i could get one up if you need it. I took the lid and cut a slit in the side where the ESC is on. I bent the plastic out "like a air scoop" or "air ram". It took about 10-15...
  2. Replies
    97
    Views
    1,991

    +1000 to all 3.

    +1000 to all 3.
  3. Replies
    7
    Views
    351

    Yes it's true the ESC and motor gets hotter when...

    Yes it's true the ESC and motor gets hotter when running any packs in series.

    Cutting a hole in the body helps somewhat but more for nitro's..

    I think duratrax makes a heat sink for that size...
  4. 12mm hex......

    12mm hex......
  5. To answer your question it could happen at any...

    To answer your question it could happen at any time but chances are if it's going to puff it typically is on a discharge or over discharge.
  6. Thread: Please Help!

    by got_nitro
    Replies
    17
    Views
    646

    Take it easy on what? I was simply asking you a...

    Take it easy on what? I was simply asking you a question.
  7. Thread: Please Help!

    by got_nitro
    Replies
    17
    Views
    646

    Thanks. So what do you have to offer up about the...

    Thanks. So what do you have to offer up about the problem other than stating what i already said in my first post about the toe in?..




    I think your right, I heard about this problem just...
  8. Thread: Please Help!

    by got_nitro
    Replies
    17
    Views
    646

    Sounds like it's cogging from a weak battery. ...

    Sounds like it's cogging from a weak battery.


    Cogging torque of electrical motors is the torque due to the interaction between the permanent magnets of the rotor and the stator slots of a...
  9. Thread: I want Lipo

    by got_nitro
    Replies
    16
    Views
    338

    http://home.comcast.net/~truerc/ready_pack/ready_p...

    http://home.comcast.net/~truerc/ready_pack/ready_packs.htm

    There are lots of packs here with higher "C" ratings then (10). Don't let the C ratings from these packs scare you away. They are the...
  10. Replies
    5
    Views
    600

    Thats a great write up. I personally HATE talons....

    Thats a great write up. I personally HATE talons. For high speed runs I would put on a set of high speed rims and tires.
    I would never go out looking for a off road tire to tape up for high speed...
  11. Thread: Toe Question

    by got_nitro
    Replies
    10
    Views
    447

    It will, but being that the TB is fixed it will...

    It will, but being that the TB is fixed it will do it all at the same time. It's real easy, do it with the tire on the truck. The hex wrench will go right in the carrier threw the spoke of the rim..
  12. Thread: Toe Question

    by got_nitro
    Replies
    10
    Views
    447

    Adjust/unscrew your pivot balls in the carriers...

    Adjust/unscrew your pivot balls in the carriers untill you get your desired tow or no tow..


    OH yeah. A toe is (one of the terminal digits of the human foot)..
  13. Replies
    13
    Views
    422

    Yeah, sometimes you get a gear with a few burrs...

    Yeah, sometimes you get a gear with a few burrs inbetween the teeth and it takes a pack or 2 to run them out but in your case (if it was mine) I would send it back for a different one. I would also...
  14. Replies
    4
    Views
    617

    Thats very odd.:confused: Usually if the ESC...

    Thats very odd.:confused: Usually if the ESC powers up fine but won't power up with the TQ on, that means your throttle trim is not on (0). A bad servo has nothing to do with the ESC or the lights...
  15. Replies
    12
    Views
    421

    Did you install the extended drive cups (that you...

    Did you install the extended drive cups (that you need for CVD's) in the rear?

    If your having a problem with the bones popping out of the cups you have to move your push rods to the outer most...
  16. Replies
    13
    Views
    422

    I agree with pop's, I would run a pack or 2 in it...

    I agree with pop's, I would run a pack or 2 in it first but IMO it deff. sounds like the ring gear is a bit lopsided or warped.

    If you spin it slow and feel it biting hard on a certin spot (like a...
  17. Replies
    17
    Views
    472

    I think your right on the money!;) :lol:

    I think your right on the money!;) :lol:
  18. Replies
    17
    Views
    472

    Funny, your profile says your 14..:confused:

    Funny, your profile says your 14..:confused:
  19. Thread: sad

    by got_nitro
    Replies
    15
    Views
    299

    I don't know how old you are but i'll assume...

    I don't know how old you are but i'll assume young and almost able to drive. Once you get your own 1.1 car that you saved up for yourself trust me, R/C will be the last thing going on in your head. ...
  20. Replies
    1
    Views
    179

    LOL... I can't say that I feel your pain but I...

    LOL... I can't say that I feel your pain but I understand the aggravation. It's much easier to attatch the T/B's to the B/C off the truck. Then all you would have to do is slide the whole thing on...
  21. Replies
    17
    Views
    472

    Did you even bother to read the TECH NOTES? I...

    Did you even bother to read the TECH NOTES?

    I underlined it for you. I don't think you will have a problem reading it but it says 12mm HEX..

    These are the HPI Mounted Super Low Tread Tires on...
  22. Thread: Awesome Vid!

    by got_nitro
    Replies
    19
    Views
    534

    Now that sound won't leave my head..:mad: ...

    Now that sound won't leave my head..:mad:

    Maybe i'll just jam out to the theme song from (Top Gun) while I pat myself on the back..:lol: :lol: :p
  23. Thread: Awesome Vid!

    by got_nitro
    Replies
    19
    Views
    534

    Look at this post i found:eek: Did i call it or...

    Look at this post i found:eek: Did i call it or what!!!....

    Same vid......:rolleyes: Nice job Fizzle...:rolleyes:
  24. Thread: Max Temp?

    by got_nitro
    Replies
    6
    Views
    804

    160-165 on the ESC yes. Thats when it will go...

    160-165 on the ESC yes. Thats when it will go into thermal protection and cut out.

    Heat really does not effect the neodymium magnets (the kind you have in your motor) untill it reaches above 200...
  25. Replies
    31
    Views
    1,355

    I had the chance to run a few packs in this thing...

    I had the chance to run a few packs in this thing since I put the aluminum on and man what a huge difference in the steering response! The steering TQ adjustment actually stayed on (0) "i didnt have...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4