Type: Posts; User: RattleSnake
I airbrushed this one for my Rustler VXL.
Except for the drive stafts which dont last long at all on 3s Lipo's.
I upgraded to MIP CV's and havent had any trouble since.
Take a look at my Rusty with a Harliquin Paint Job in the photo...
My first paint Job using Spaztix paint!
I have bought 3 ******* accucell 6's now, 2 for workmates and 1 to work along side my Imax B6.
Both the ******* accucell's for my workmates needed the fans to be lubricated as they slowly got...
why dont you just limit the amount of throttle when using 3s lipo's to the same level of power as a 2s?
You would get loads more run time running a 3s at say %60 throttle than a 2s at %100 for the...
I have tried both 3000kv and 4300kv EzRun motors in my stampede on 4400mah 3sLipo and the 60 amp EzRun esc.
I have also put in a Sidewinder 4600kv combo in which was faster than the EzRun but was...
Brushless motors are different to Brushed motors, each needs a seperate ESC.
Well said :lol:
If there is any air in the shock and it is upsidedown, the plunger inside the shock would start off its stroke in air, and not oil untill it is compressed enough to move into the oil.
I found them on Ebay .
Thats not quite true.
Batteries in Series: eg. 2x 7.4v 4000mah in series gives you an effective battery of 14.8v 4000mAH.
Batteries in Paralell: eg. 2x 7.4v 4000mah in paralell...
I would think the 56t spur is way to small, why dont you have the 83 or larger 86t stampede spur in there?
Just worried that you'll overload your motor.
I had the 60 amp esc and both 4300kv and 3000kv versions in my stampede.
On 3s Lipo it was drawing 59amps with the 4300kv and around 50amps with the 3000kv.
While it is the best budget brushless...