Type: Posts; User: coolt21902
I have the tmaxx 2.5 axles in my slash 4x4 all the way around, it dows take some work though. there is a thread on here somewhere on how to install them
no beadlock wheels on the mini
if you run a 22t pinion and a 54t spur you would be in the neighborhood of 44mph. so i think yes 50mph on 3s could be achieved
it does work but there is more to it then just putting the rear arms up front.
i know the link is for a stampede but it...
I understand your frustration with the 1/10th scale slash 4x4 overheating. I have the same issue as well and i even had it geared as low as possible and the speed control would still have heat. i...
i just watched that video the other day and gave it a try. it works well, but you have to be patient. do like it says put them in and walk away for 24 hours
tower has chassis for $9.39. no need to buy a new stampede, just get the parts that broke
when i did my revo 3.3 conversion i didnt need to use a plate i just took the springs out, and put a screw in front of each of the arms that come out to shift into second gear. the screws hold the...
if you have a eletric stampede you dont want either of those. they are for a nitro stampede which has shorter a arms then the electric. you want these...
you would have to run the hole 2wd axle set since the hole size at the joints are bigger on the 4x4
If you want a ford raptor body then you should have bought a Jconcept Gladiator body before they quick makingthem, it was almost identical
Hey Peter, I sent you a email back on 2-28, just wondering if you got it or not.
heres my 2008 kfx450r and my 2000 kx250
I put a center diff in my revo with the 500k diff oil, im wanting to know do i go thicker or thinner to put less power to the front and more to the rear
did you have to cut the drive cups down. i tried the mip ccvds that i have for my 2 wheels drive slash and the axle would bind in the cup when the suspensions compresses fully
EPA is End Point Adjustment
you can also find refillable air cans that you rill with any air compressor
i just picked up a bandit and was looking at getting a new body but when i looked on tower they only have 3 bodies listed. i want to keep it a buggy body. any input on what other bodies fit well...
i have several sets and the only time i have broken them is in my rusty with rpm arms and that is becuase at full suspension up travel the dogbone would catch in the cup bind up and snap. since then...
i have the 4 wheelparts truck and i got it through my lhs
the other thing to check on the servo not centering is to make sure the screws in the skid plate that go through the steering arms are not to tight. that happened on mine. would hang up to which ever...
i beleive they are the same as the stampede and rustler. not sure what the x in the part number for the 4x4 slash means
i tried some nitro rear offset wheels i have from my rustler and they will work on the rear but nowhere close on the front
well i would have had mine today but ups wouldnt unload the truck for the lhs to pick them up, so it wont be until monday now.
i have the integy tranny for both my rustler and my slash, all my holes lined up great, and i saw about a 25 degree drop in motor temps after a full 11.1v 5000mah battery